Stainless Steel Hose Bender for 3/4-Inch ID Hose

This stainless steel hose bender helps maintenance and plumbing professionals route straight hose into a controlled shape. It supports cleaner hose paths around equipment, walkways, and other areas where kinks or repeated bending can be a concern.

Designed for 3/4-inch inside-diameter hose with a maximum 1.09-inch outside diameter, this hose bender slides over the hose and is positioned with its spine inside the desired bend. Each coil can be formed up to 90 degrees; additional coils can be used for bends of 180 degrees or more. Stainless steel construction is suitable for above-ground, below-ground, and underwater use. No special tools or equipment are required. Effective minimum order: 11 each.

Key Features:

• Hose routing support: Helps hold hose in a planned bend for more orderly routing around work areas and equipment.
• Kink reduction: Helps reduce hose kinking and fatigue associated with repeated bending.
• Stainless steel construction: Provides rust-resistant construction for use in wet or underground environments.
• Slide-on installation: Installs by sliding over the hose and bending the spine into position without special tools.
• 90-degree bend capability: Allows each coil to form bends up to 90 degrees, with additional coils supporting larger turns.

Choose this hose bender when routing 3/4-inch ID hose with an outside diameter up to 1.09 inches and a maintained bend is needed. It is a practical option for directing hose paths while helping minimize kinks.

No additional information available.