Stainless Steel Hose Bender for 1/4 in. I.D. Hose

This hose bender helps maintenance and plumbing professionals route 1/4 in. I.D. hose into a controlled shape. It supports cleaner hose placement around equipment, walkways, and other areas where an unsupported hose path may be undesirable.

Constructed of stainless steel, this hose bender fits hose with a 1/4 in. inside diameter and up to a 0.52 in. outside diameter. Slide it over the hose, position the spine on the inside of the intended bend, and press the spine to form the angle. Each coil can be bent up to 90 degrees; additional coils can be used for bends of 180 degrees or more. It can be used above ground, below ground, or underwater.

Key Features:

• Hose routing support: Helps hold hose in the desired path after bending.
• Kink reduction: Helps reduce kinking and fatigue caused by repeated bending.
• Stainless steel construction: Provides rust-resistant construction for varied environments.
• Tool-free installation: Slides over the hose without special tools or equipment.
• 90-degree bend per coil: Allows controlled hose routing, with additional coils supporting larger bends.

Choose this hose bender for 1/4 in. I.D. hose when a formed routing path and kink reduction are needed. The effective minimum order is 13 units.

No additional information available.