Gray Steel Sloped Control Enclosure - 10.75 W x 13.75 H x 14 D

This gray steel sloped control enclosure is for installers and equipment users mounting small control or instrumentation devices. Its angled access surface helps position devices for convenient operation on desktops, pedestals, and other flat surfaces.

The enclosure is made of 14-gauge steel with continuously welded, smooth-ground seams. It measures 10.75 inches wide, 14 inches deep, and 13.75 inches high. It has no holes or knockouts, can be mounted on either of two sides, and supports a 30- or 60-degree access surface. The cover uses captive screws that thread into sealed wells, includes a bonding provision and oil-resistant gasket, and has a control panel attached by a continuous hinge along the bottom edge.

Key Features:

• Sloped access surface: Provides an angled mounting area for small controls or instrumentation devices.
• Two-side mounting: Allows placement on a desktop, pedestal, or other flat surface in either of two orientations.
• Welded steel construction: Continuously welded and smooth-ground seams create a finished enclosure exterior.
• No holes or knockouts: Lets buyers configure openings based on their installation requirements.
• Hinged control panel: The continuous bottom hinge supports access to the attached control panel.
• Sealed cover hardware: Captive cover screws thread into sealed wells, while the oil-resistant gasket helps seal the cover.

Choose this enclosure for small control or instrumentation installations that need a gray steel housing with a sloped operating surface and flexible flat-surface placement.

No additional information available.