Electrical Boxes, Wiring & Cable

This 1/2-gang poke-through pass-through housing assembly is for commercial electrical installers and facility teams routing cables through floor box locations. It provides a pass-through path while...

This aluminum conduit body cover is used by electrical installers to seal conduit bodies and help protect enclosed electrical wires. It is designed for 1/2-inch conduit body applications.The cover is...

This 1/2-inch bronze grounding hub is for electrical installers connecting rigid conduit to steel water pipe as part of a grounding setup. Used with grounding pipe clamps, it provides the connection...

This 100-pack of 1/2-inch conduit hangers is for electrical installers and maintenance teams that need to secure and suspend EMT, PVC, or rigid conduit in overhead applications. Each hanger helps...

These carbon steel locknuts are used by electrical installers to secure threaded rigid conduit or IMC fittings to steel boxes, panels, and enclosures. The 100-pack supports conduit fastening work...

This clamp-on service entrance cap provides an overhead service-entry point where power wires enter a building. Electrical installers use it on compatible conduit to help route multiple service...

These 1/2-inch conduit nipples are for electrical installers connecting threaded conduit to enclosure knockouts with locknuts. They also provide a short raceway between boxes or enclosures.Made of...

This 1/2-inch LL threaded conduit body is for electrical installers working with conduit systems. It provides an access point inside the run to support wire pulling, splicing, and maintenance work...

These 1/2-inch no-thread conduit connectors are for electrical contractors and maintenance teams connecting IMC or rigid conduit to metal enclosures. The 25-pack supports installation work that...

This 1/2-inch no-thread conduit coupling is for electrical professionals joining two lengths of threadless rigid or IMC conduit. It provides a direct connection point for completing conduit runs.Made...

This 25-pack of 1/2-inch offset nipples is for electrical professionals connecting boxes or panels. Each fitting helps offset the axis between two raceways for alignment during installation.These...

These one-hole pipe straps are for electrical installers fastening rigid or IMC conduit to wood, masonry, and other working surfaces. The 100-pack supports conduit-routing work that requires secure...

These straight insulated liquid-tight connectors help electricians and electrical contractors connect metallic or non-metallic liquid-tight conduit to weatherproof outlet boxes and other electrical...

These straight liquid-tight conduit connectors are for electrical professionals connecting metallic or non-metallic liquid-tight conduit to a box or enclosure. They provide a direct connection point...

This 10 AWG orange building wire is for electrical contractors and commercial or industrial maintenance teams routing conductors through conduit or cable trays. It supports service, feeder, and...

This 10 gauge yellow building wire is for commercial and industrial electrical installers routing conductors through conduit and cable trays. It supports service, feeder, and branch-circuit wiring...

This 10-gauge black GPT primary wire is for technicians and fleet or vehicle maintenance teams wiring low-voltage surface vehicle electrical systems. Its 100-foot spool provides wire for primary...

This 25 ft metal clad cable is for electrical professionals installing branch feeder and service power distribution, as well as power, lighting, control, and signal circuits in commercial,...

This 10/2 AWG UF-B cable is for electrical professionals and property maintenance teams running feeder wiring to outdoor loads from an existing building distribution point. Its 50-foot length helps...

This 10/3 NM-B cable with ground is for electrical professionals completing exposed or concealed wiring work in normally dry locations. Its 250-foot length provides cable for installations where a...