This water removal system is designed for commercial and residential drainage applications where an above-floor solution is needed. It helps move water from laundry trays, lavatory sinks, wet bar sinks, dehumidifiers, and water softeners without requiring a sump excavation.
The preassembled 115 V, single-phase system includes a 1/3 HP submersible pump, discharge pipe, and 5-gallon basin. It delivers up to 46 gal/min or 2,760 gal/hr, uses an integral diaphragm float switch, and has a 1-1/2 in FNPT discharge connection. The unit has a 15-5/8 in height, 9 ft cord, cast-iron construction, nylon impeller, stainless-steel shaft, and carbon/ceramic shaft seal.
Key Features:
- Above-floor installation: Provides a water-removal option without digging a sump pit.
- Preassembled system: Supplies the pump, basin, discharge pipe, and listed adapters together for installation planning.
- 5-gallon basin: Provides collection capacity for connected drainage sources.
- Integral diaphragm switch: Supports automatic pump operation in the system.
- 46 gal/min flow rate: Moves water at up to 2,760 gal/hr for drainage applications.
- 1-1/2 in discharge connection: Supports connection to compatible discharge piping.
Choose this system for above-floor water removal from compatible drainage sources where a 115 V, 1/3 HP pump and 5-gallon basin fit the installation requirements. Effective minimum order: 1.
Product Documents
| Capacity: |
5 gal |
| Country of Origin: |
MX |
| Motor: |
1/3 HP |
| Product Depth: |
14.75 |
| Product Height: |
15.625 |
| Product Type: |
Bin |
| Product Width: |
17.25 |
| Voltage: |
115 V |
| Cord Length: |
9 ft |
| Discharge Connection Size: |
1-1/2 in |
| Max Diameter Solids: |
1/18 in |
| Amperage: |
9 A |
| Continuous Operation: |
Yes |
| Discharge Connection Type: |
FNPT |
| Float Switch: |
Yes |
| Gallons per Hour: |
2760 gal/hr |
| Gallons per Minute: |
46 gal/min |
| Hertz: |
60 Hz |
| Horsepower: |
1/3 HP |
| Impeller Material: |
Nylon |
| Includes: |
(2) 1-1/2 MNPT X 2 Slip Adapt (Inlet) & (1) 2 MNPT X 1-1/2 Slip Adapt (Vent) |
| Material: |
Cast Iron |
| Max Fluid Temperature: |
125 °F |
| Max Pressure: |
9.1 psi |
| Phase: |
1 |
| Series: |
WRS |
| Shaft Material: |
Stainless Steel |
| Shaft Seal Material: |
Carbon/Ceramic |
| Solids Handling: |
Yes |
| Submersible: |
Yes |
| Switch Type: |
Integral Diaphragm |
| Temperature of Liquid Pumped: |
125 |
| Type: |
Water Removal System |
| Warranty: |
3 |
| Certifications: |
CSA |
| Shipping Method: |
Parcel |
No additional information available.